Firmware Download
V1.0.6
Release Notes
- [BUG] Fixed an issue introduced in version 1.0.5 where the heating fan could not start properly.
V1.0.5
Release Notes
- [Feature] The activation page now supports entering the activation code using the touchscreen.
- [Feature] Added “RGB Max Brightness” in System Settings, allowing you to set the maximum brightness of the four RGB LEDs.
- [Feature] Added “RGB Sleep with Screen” in System Settings. When enabled, the RGB LEDs turn off when the screen sleeps and turn back on when the screen wakes.
- [Improvement] When one sensor (such as INA226 or AHT20) fails, readings from other sensors (e.g., MCU temperature, heating plate temperature) will still be displayed normally.
V1.0.4
Release Notes
- Fixed an issue introduced in version 1.0.3 where the rotary encoder could not be used to operate certain interface elements.
V1.0.3
Release Notes
- Optimized heating driver, significantly reducing MOSFET temperature (by 40 °C+).
V1.0.2
Release Notes
- Optimized the situation where the screen is occasionally misidentified as a touchscreen when using a non-touchscreen, leading to false touches.
V1.0.1
Release Notes
- The over-temperature protection limit of the heater plate has been increased from 120 °C to 150 °C.
- The sensor error detection logic has been optimized and will now only be checked when the heating function is enabled.
V1.0.0
Release Notes
- Initial release
What You Get After Downloading
The firmware archive contains the following files for flashing:
SmartChamber-3D.bootloader.binSmartChamber-3D.partitions.binSmartChamber-3D.ino.bin
Upgrade Advice
- When upgrading from an older version, you do not need to erase Flash, to avoid losing custom parameters.
- Only erase Flash for the first flash or if firmware is abnormal.